EasyManuals Logo

Juniper QFX5200 User Manual

Juniper QFX5200
216 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #133 background imageLoading...
Page #133 background image
For standard Junos OS systems:
[edit]
root@# set interfaces em0 unit 0 family inet address
ip-address/prefix-length
For Junos OS Evolved systems:
[edit]
root@# set interfaces re0:mgmt-0 unit 0 family inet address
ip-address/prefix-length
CAUTION: Although the CLI permits you to congure two management Ethernet
interfaces within the same subnet, only one interface is usable and supported.
NOTE: On the QFX5200-48Y, the management port em0 is the top right-hand RJ-45 port on
the port panel.
9. (Oponal) Congure the stac routes to remote prexes with access to the management port.
[edit]
root@# set routing-options static route remote-prefix next-hop
destination-ip
retain no-
readvertise
10. Enable services such as SSH and Telnet.
NOTE: You will not be able to log in to the switch as the root user through Telnet. Root login
is allowed only through SSH.
The default opon for SSH is yes. Select this to enable SSH.
The default opon for Telnet is no. Change this to yes to enable Telnet.
124

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper QFX5200 and is the answer not in the manual?

Juniper QFX5200 Specifications

General IconGeneral
BrandJuniper
ModelQFX5200
CategorySwitch
LanguageEnglish

Related product manuals