Juniper SG 20 - Basic Device Configuration; Root Admin Name and Password

Basic Device Configuration  33
Basic Device Configuration
This section describes the following basic configuration settings:
 Root Admin Name and Password
 Date and Time
 Bridge Group Interfaces
 Administrative Access
 Management Services
 Hostname and Domain Name
 Default Route
 Management Interface Address
 Backup Untrust Interface Configuration
Root Admin Name and Password
The root admin user has complete privileges for configuring an SSG 20 device. We
recommend that you change the default root admin name and password (both
netscreen) immediately.
To change the root admin name and password, use the WebUI or CLI as follows:
WebUI
Configuration > Admin > Administrators > Edit (for the netscreen
administrator name value): Enter the following, then click OK:
Administrator Name:
Old Password: netscreen
New Password:
Confirm New Password:
CLI
set admin name name
set admin password pswd_str
save
NOTE:
Passwords are not displayed in the WebUI.