Juniper SG 20 - Administrative Access; Management Services

Basic Device Configuration  35
CLI
unset interface bgroup0 port ethernet0/3
unset interface bgroup0 port ethernet0/4
set interface bgroup1 port ethernet0/3
set interface bgroup1 port ethernet0/4
set interface bgroup1 port wireless0/2
set interface bgroup1 zone DMZ
set interface bgroup1 ip 10.0.0.1/24
save
Administrative Access
By default, anyone in your network can manage a device if they know the login and
password.
To configure the device to be managed only from a specific host on your network,
use the WebUI or CLI as follows:
WebUI
Configuration > Admin > Permitted IPs: Enter the following, then click Add:
IP Address/Netmask: ip_addr/mask
CLI
set admin manager-ip ip_addr/mask
save
Management Services
ScreenOS provides services for configuring and managing the device, such as
SNMP, SSL, and SSH, which you can enable on a per-interface basis.
To configure the management services on the device, use the WebUI or CLI as
follows:
WebUI
Network > Interfaces > List > Edit (for ethernet0/0): Under Management
Services, select or clear the management services you want to use on the
interface, then click Apply.
CLI
set interface ethernet0/0 manage web
unset interface ethernet0/0 manage snmp
save