Juniper SRX220

CHAPTER 13
Connecting, Grounding, and Powering On
the Services Gateway
•
Connecting the SRX220 Services Gateway to the Power Supply on page 91
•
Connecting and Organizing Interface Cables for the SRX220 Services
Gateway on page 92
•
Grounding the SRX220 Services Gateway on page 93
•
Powering On and Powering Off the SRX220 Services Gateway on page 94
•
Resetting the SRX220 Services Gateway on page 97
Connecting the SRX220 Services Gateway to the Power Supply
CAUTION: Before connecting the device to the power supply, attach an
electrostatic discharge (ESD) strap to an ESD point and place the other end
of the strap around your bare wrist.
To connect the device to the power supply:
1. Plug the DC connector end of the power cable into the power connector on the back
of the device (see Figure 17 on page 92).
2. Secure the DC connector end of the power cable in the power connector, using a
plastic cable tie, as shown in Figure 17 on page 92.
3. Plug the AC adapter end of the power cable into an AC power outlet.
91Copyright © 2012, Juniper Networks, Inc.