Table 42: Services Gateway Power LED Status
Possible Cause and Corrective ActionMeaningLED Status
Normal indication. No action is required.The device is receiving power,
and the internal power supply is
functional.
Green
Normal indication. No action is required.The Power button has been
pressed and quickly released.
The device is shutting down or
starting up.
Amber
•
Verify that the AC power cord from the
power source to the device is not damaged.
If the insulation is cracked or broken,
immediately replace the cord or cable.
•
Ensure that the socket you plug into is in
working condition.
•
Ensure that the device has an AC input
voltage between 110 and 240 VAC.
•
If you cannot determine the cause of the
problem or need additional assistance,
contact the Juniper Networks Technical
Assistance Center (JTAC). See Related
Topics.
The device is not receiving
power.
Off
Related
Documentation
• Monitoring the SRX220 Services Gateway Chassis Using the CLI on page 127
• Monitoring the SRX220 Services Gateway Components Using LEDs on page 128
• Monitoring the SRX220 Services Gateway Using Chassis Alarm Conditions on page 131
• Using the Reset Config Button on the SRX220 Services Gateway on page 135
• Changing the Reset Config Button Behavior on the SRX220 Services Gateway on
page 136
• Juniper Networks Technical Assistance Center on page 139
133Copyright © 2012, Juniper Networks, Inc.
Chapter 19: Monitoring Hardware Components
To Next Page
Loading...
Need help?
General
