EasyManuals Logo

Juniper SRX220 User Manual

Juniper SRX220
170 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
som bruker et spesielt verktøy, lås og nøkkel, eller en annen
sikkerhetsanordning, og det kontrolleres av den autoriteten som er ansvarlig
for området.
Aviso Esta unidade foiconcebidapara instalaçãoem áreas de acessorestrito.
Uma área de acesso restrito é uma área à qual apenas tem acesso o pessoal
de serviço autorizado, que possua uma ferramenta, chave e fechadura
especial, ou qualquer outra forma de segurança. Esta área é controlada pela
autoridade responsável pelo local.
¡Atención! Esta unidad ha sido diseñada para instalarse en áreas de acceso
restringido. Área de acceso restringido significa un área a la que solamente
tiene accesoel personal de servicio mediante lautilización de una herramienta
especial, cerradura con llave, o algún otro medio de seguridad, y que está
bajo el control de la autoridad responsable del local.
Varning! Denna enhet är avsedd för installation i områden med begränsat
tillträde. Ett område med begränsat tillträde får endast tillträdas av
servicepersonal med ett speciellt verktyg, lås och nyckel, eller annan
säkerhetsanordning, och kontrolleras av den auktoritet som ansvarar för
området.
Preventing Electrostatic Discharge Damage to the Services Gateway
Many services gateway hardware components are sensitive to damage from static
electricity. Some components can be impaired by voltages as low as 30 V. You can easily
generate potentially damaging static voltages whenever you handle plastic or foam
packing material or if you move components across plastic or carpets. Observe the
following guidelines to minimize the potential for electrostatic discharge (ESD) damage,
which can cause intermittent or complete component failures:
Always use an ESD wrist strap or ankle strap, and verify that it is in direct contact with
your skin.
CAUTION: For safety, periodically check the resistance value of the ESD
strap. The measurement should be in the range of 1 to 10 Mohms.
When handling any component that is removed from the chassis, verify that the
equipment end of your ESD strap is attached to one of the ESD points on the chassis.
Avoid contact between the component and your clothing. ESD voltages emitted from
clothing can damage components.
When removing or installing a component, always place it component-side up on an
antistatic surface, in an antistatic card rack, or in an electrostatic bag. If you are returning
a component, place it into an electrostatic bag before packing it. See Figure 9 on
page 55.
Copyright © 2012, Juniper Networks, Inc.54
SRX220 Services Gateway Hardware

Table of Contents

Other manuals for Juniper SRX220

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX220 and is the answer not in the manual?

Juniper SRX220 Specifications

General IconGeneral
Product NameJuniper SRX220
CategoryGateway
Firewall Throughput750 Mbps
Maximum Concurrent Sessions64, 000
Memory1 GB DRAM
Flash Memory1 GB
Concurrent Sessions64, 000
Operating SystemJunos OS
Weight2.5 kg
Interfaces8 x 10/100/1000 Ethernet
Power SupplyAC 100-240V, 50-60Hz
Ports8 x 10/100/1000 Ethernet
Storage1 GB

Related product manuals