3. Optionally, configure additional properties by adding the necessary configuration
statements. Then commit the changes to activate them on the services gateway.
[edit]
admin@# commit
4. When you have finished configuring the services gateway, exit configuration mode.
[edit]
admin@# exit
admin@>
Safety Warnings
WARNING: See installation instructions before connecting the services
gateway. This is a summary of safety warnings. For a complete list of warnings
for the services gateway, including translations, see the SRX3600 Services
Gateway Hardware Guide at http://www.juniper.net/techpubs/hardware/ .
WARNING: The intrabuilding port(s) of the services gateway is suitable for
connection to intrabuilding or unexposed wiring or cabling only. The
intrabuilding port(s) of the services gateway MUST NOT be metallically
connected to interfaces that connect to the OSP or its wiring. These interfaces
are designed for use as intrabuilding interfaces only (Type 2 or Type 4 ports
as described in GR-1089-CORE, Issue 4) and require isolation from the
exposed OSP cabling. The addition of primary protectors is not sufficient
protection to connect these interfaces metallically to OSP wiring.
CAUTION: Before removing or installing components of a services gateway,
attach an ESD strap to an ESD point and place the other end of the strap
around your bare wrist. Failure to use an ESD strap could result in damage
to the services gateway.
CAUTION: An external Surge Protective Device (SPD) should be used at the
AC input of the services gateway.
•
Only trained and qualified personnel should install or replace the services gateway.
•
Perform only the procedures described in this guide or the SRX3600 Services Gateway
Hardware Guide. Other services should be performed by authorized service personnel
only.
•
Read the installation instructions before you connect the services gateway to a power
source.
Copyright © 2011, Juniper Networks, Inc.24
SRX3600 Services Gateway Getting Started Guide
To Next Page
Loading...
Need help?
General
