Juniper SRX380 User Manual

Quick Start Guide
SRX380 Services Gateway
IN THIS GUIDE
SRX380 Services Gateway Overview | 1
Register the Product | 1
SRX380 Front Panel and Rear Panel | 2
SRX380 Services Gateway Physical Specifications | 3
Factory-Default Settings | 3
Install the SRX380 in a Rack | 4
Connect to Ground | 6
Connect Power to the Device | 7
Configure Root Authentication | 8
Plug and Play | 9
Configure the SRX380 Using J-Web | 10
Next Steps | 11
SRX380 Services Gateway Overview
The Juniper Networks SRX380 Services Gateway consolidates security, routing, switching to provide an all-in-one
networking platform for SD-WAN and NGFW deployments. The services gateway is designed for enterprise (large branch
offices, small campus, SD-WAN) and service provider (managed WAN CPE, SD-WAN) deployments. For more information
on the SRX380 hardware, see the SRX380 Services Gateway Hardware Guide.
Register the Product
Register product serial numbers on the Juniper Networks website and update the installation base data if there is any
addition or change to the installation base or if the installation base is moved. Juniper Networks will not be held accountable

Juniper SRX380 Specifications

General

Firewall Throughput	20 Gbps
IPSec VPN Throughput	4 Gbps
Memory	8 GB
MTBF	200, 000 hours
Form Factor	1U
Concurrent Sessions	1, 000, 000
Interfaces	16 x 1GbE, 4 x 10GbE
Power Supply	Dual redundant AC or DC
Operating Temperature	32° to 104° F (0° to 40° C)
Storage Temperature	-4° to 158° F (-20° to 70° C)
Humidity	5% to 90% non-condensing

Summary

SRX380 Services Gateway Overview

Register the Product

Register product serial numbers on the Juniper Networks website to update installation base data.

SRX380 Front Panel and Rear Panel

Factory-Default Settings

Install the SRX380 in a Rack

Securing Front Brackets to Rails

Securing Mounting Rails to SRX380

Positioning SRX380 in Rack

Securing SRX380 with Rack Mount Screws

Sliding Mounting Blades into Rails

Connect to Ground

Grounding Procedure

Instructions for properly grounding the SRX380 Services Gateway using an ESD strap and grounding cable.

Connect Power to the Device

AC Power Connection Steps

Detailed steps on how to connect the AC power cord, including using the retainer clip.

Configure Root Authentication

Management Device Connection

Steps to connect the SRX380 to a management device via an Ethernet cable for initial configuration.

Configure the SRX380 Using J-Web

J-Web Setup Wizard Introduction

Information required and the initial step to launch the J-Web Setup wizard.

Standard Mode Configuration

Steps to select and configure the SRX380 in Standard Mode via the J-Web wizard.

Time and DNS Configuration

Setting time, time zone, and DNS server IP address in the J-Web wizard.

Management Interface Configuration

Configuring the management port IP address and static route within the J-Web wizard.