NOTE: The device is not shipped with AC power cords. Make sure to order or obtain AC power
cords with a plug appropriate for your geographical location.
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis. For more information about ESD, see the SRX5400 Services
Gateway hardware documentation at www.juniper.net/documentation/.
2. Locate the power cords you will use to connect the device to AC power. See the SRX5400 Services
Gateway hardware documentation at www.juniper.net/documentation/ for specifications.
3. For each power supply:
a. Move the power switch on the power supply faceplate to the OFF position (O).
b. Insert the appliance coupler end of the power cord into the appliance inlet on the power supply
(Figure 10 on page 20).
c. Insert the power cord plug into an external AC power source receptacle.
NOTE: Each power supply must be connected to a dedicated AC power feed and a dedicated
customer site circuit breaker. We recommend using a 15-A (250-VAC), circuit breaker
minimum, or as permitted by local code.
d. Dress the power cord appropriately. Verify that the power cord does not block the air exhaust or
access to services gateway components, and that it does not drape where people could trip over
it.
19
To Next Page
Loading...
