•
Ensure that the cabinet allows the chassis hot exhaust air to exit from the cabinet without recirculating
into the services gateway.
•
The services gateway must be installed into a rack that is secured to the building structure.
•
Mount the services gateway at the bottom of the rack if it is the only unit in the rack.
•
When mounting the services gateway in a partially filled rack, load the rack from the bottom to the top
with the heaviest component at the bottom of the rack.
Tools Required to Unpack and Prepare the SRX5400 Services Gateway for
Installation
To unpack the services gateway and prepare for installation, you need the following tools:
•
A mechanical lift—recommended
•
Phillips (+) screwdrivers, numbers 1 and 2
•
2.5-mm flat-blade (–) screwdriver
•
7/16-in. torque-controlled driver or socket wrench
•
1/2-in. or 13-mm open-end or socket wrench to remove bracket bolts from the shipping pallet
•
Electrostatic discharge wrist strap
•
Antistatic mat
Proceed to “Step 2: Install the Mounting Hardware in a Four-Post Rack or Cabinet or an Open-Frame
Rack” on page 6.
Step 2: Install the Mounting Hardware in a Four-Post
Rack or Cabinet or an Open-Frame Rack
To install the mounting shelf on the front rails of a four-post rack or cabinet, or on the rails of an open-frame
rack:
1. If needed, install cage nuts in the holes specified in Table 2 on page 7.
2. On the back of each rack rail, partially insert a mounting screw into the lowest hole specified in
Table 2 on page 7.
6
To Next Page
Loading...
Need help?
General
