Step 7: Perform the Initial Software Configuration
IN THIS SECTION
Enter Configuration Mode | 23
Configure User Accounts and Passwords | 24
Configure System Attributes | 24
Commit the Configuration | 26
Enter Configuration Mode
1. If you have not already done so, switch the circuit breaker or toggle switch for each power supply to
the ON position to start the device. The OK LED on the power supply faceplate should blink, and then
light steadily.
2. Log in as the root user. There is no password.
3. Start the CLI.
root# cli
root@>
4. Enter configuration mode.
configure
[edit]
root@#
23
To Next Page
Loading...
