Juniper SRX5400 - Step 6: Connect Power Cables; Connect Power to an AC-Powered Services Gateway

CAUTION: Avoid bending a fiber-optic cable beyond its minimum bend radius. An
arc smaller than a few inches in diameter can damage the cable and cause problems
that are difficult to diagnose.
CAUTION: Do not let fiber-optic cables hang free from the connector. Do not allow
the fastened loops of a cable to dangle, which stresses the cable at the fastening point.
Proceed to “Step 6: Connect Power Cables” on page 18.
Step 6: Connect Power Cables
IN THIS SECTION
Connect Power to an AC-Powered Services Gateway | 18
Connect Power to a DC-Powered Services Gateway | 20
Depending on its configuration, the services gateway uses either AC or DC power supplies. Perform the
appropriate procedures for each power supply in the services gateway.
Connect Power to an AC-Powered Services Gateway
WARNING: To meet safety and electromagnetic interference (EMI) requirements and
to ensure proper operation, you must properly ground the services gateway chassis
before connecting power. See “Step 4: Connect the Grounding Cable” on page 14 for
instructions.
18