30
Estimated time for this step: 5 minutes
It’s important to confirm that everything is working before packing up your tools. Take a few moments to
test your work.
1. Use the following baseline settings to start:
Master volume at 18
All microphone volumes at 5
All device volumes at 15
2. Put on the microphone and turn it on.
3. Turn on the Tower.
4. Walk, talk, and listen to the sound quality (find another person to
help you with this step: It’s difficult to assess your own voice).
5. Try to find any areas where the receiver is not picking up
your signal (see Troubleshooting if this happens).
6. Try to find any areas where you experience acoustic feedback
(squealing). Turn down the volume in small increments until
the feedback disappears.
NOTE: If you have installed external speakers, make sure you have balanced the Juno Tower speakers and
the external speakers properly (see page 23).
Ask another person to assess volume levels
from front and back of room while you speak
top view
Test system
To Next Page
Loading...