JUNTTAN PM 20L - Safety Section; Important Aspects of Safety; Safety Aspects Regarding the Machine

JUNTTAN Safety section
8
2. SAFETY SECTION
2.1 IMPORTANT
ASPECTS OF
SAFETY
Pay special attention to the sections
which are identified with Safety Alert
Symbol. Follow the instructions in the
safety message.
n WARNING
n DANGER
n ATTENTION
You should read and understand all
the safety instructions and operating
instructions before you start using,
maintaining, lubricating or repairing
this machine.
Accidents can be caused by ignorance
of instructions, neglect of safety
measures and carelessness.
A person operating, servicing or
repairing should always be alert and
have adequate training and skill to
operate the machine and conduct the
other actions properly and according
to the instructions. An operator is
responsible for the proper use of the
machine.
Incorrect use, lubrication or repair
can be dangerous and lead to physical
injury or damage to the machine.
The instructions in these manuals,
specifications, illustrations and
drawings are based on the
information available at the time of
writing.
The above information can be
changed. These changes may affect
the use, lubrication, service and
repair procedures. Junttan or its
dealer will provide you with
up-to-date information regarding the
operation and maintenance of this
machine.
If the operator’s manual is missing or
worn out you can get a new one from
Junttan or its dealer.
Safe and efficient operation of this
machine requires that it be
maintained in good condition and
that its operator be thoroughly
familiar with the controls and the
general capability of the machine.
2.2 SAFETY ASPECTS
REGARDING THE
MACHINE
The fluids used in the machine are
flammable and smoking is forbidden
during fill up and maintenance of the
fuel system.
The hydraulic oil is under pressure
during operation and can be hot.
Prior to disconnecting any parts from
the hydraulic system make sure that
you relieve the pressure.
Take adequate measures when
working with hot machine parts.
The batteries of the machine contain
corrosive acid and may develop toxic
or explosive gases. Do not smoke,
avoid creation of sparks when
working with the batteries, and be
careful not to tip the batteries over
when lifting them.