JUNTTAN PM 20L - Page 96

JUNTTAN Routine service section
96
JUNTTAN ROUTINE SERVICE CHART PM 20
DAILY OR EVERY 8 HOURS
Object: Measure:
Engine crankcase oil Check oil level
Coolant Check coolant level
Hydraulic tank oil Check oil level
Machine Walk-Around inspection
Lifting devices Walk-Around inspection
Cross joint Grease and check
Indicators and gauges Test
Emergency stops Test
AFTER EACH 40 HOURS/WEEKLY
1. Grease the slewing ring ball races (lubrication pipes with grease nipples are in the
hydraulic compartment).
2. Grease the nipples in the upper and lower slide.
3. Grease the nipples in the upper and lower swivels of the inclination cylinders.
4. Grease the nipples in the stabilizers (optional).
5. Grease the nipples of the leader guides.
6. Apply grease with a brush to the bottom of the horizontal slide.
7. Grease the nipples of the leader lift device .
8. Check the bearings of the sheaves (the bearings are lubricated for life).
9. Check the condition of the ropes and lubricate them with brush (see standard ISO
4309).
10. Grease the slewing ring pinion gear.
11. Check the play of the track frame slide beams.
12. Check the bearings of the winches top limit in the cathead.
13. Check the level of the electrolyte in the batteries, clean batteries and terminals.
14. Check the track drive transmission oil level.
15. Check the swing drive transmission oil level.
16. Check the inclinometer calibration.
MONTHLY
17. Grease the nipples in the cathead.