Jupiter AX411 Access Point User Manual

• Providing Power to the AX411 Access Point Using Power over Ethernet on page 33
• Providing Power to the AX411 Access Point Using the Power Supply on page 34
Installing the AX411 Access Point Antennas
If you are not mounting the AX411 Access Point in an enclosure or other arrangement that
uses external antennas, install the three antennas provided with the access point. To
install the access point antennas:
1. Locate the three antennas supplied with the access point.
2. Engage each antenna with the connector on the rear panel of the access point and
tighten its thumbscrew until snug.
Related
Documentation
AX411 Access Point Connection Overview on page 31•
• Connecting External Antennas to the AX411 Access Point on page 27
• Providing Power to the AX411 Access Point Using Power over Ethernet on page 33
• Providing Power to the AX411 Access Point Using the Power Supply on page 34
Connecting the AX411 Access Point to the SRX Series Device
To connect the AX411 Access Point to the SRX Series device:
1. Locate the port on the SRX Series device to which you are connecting the access
point. We recommend that you use a port other than ge-0/0/0 unless you are using
an advanced configuration. If you are providing power to the access point using Power
over Ethernet (PoE), make sure that the port supports PoE.
2. Connect one end of a CAT5e or CAT6 Ethernet cable to the intended port on the SRX
Series device.
3. Connect the other end of the cable to the Ethernet port on the access point.
Related
Documentation
AX411 Access Point Connection Overview on page 31•
• Installing the AX411 Access Point Antennas on page 33
• Providing Power to the AX411 Access Point Using Power over Ethernet on page 33
• Providing Power to the AX411 Access Point Using the Power Supply on page 34
Providing Power to the AX411 Access Point Using Power over Ethernet
The preferred method of supplying power to the AX411 Access Point is with Power over
Ethernet (PoE). This technology allows the transmission of electrical power to remote
devices over the same cables that the Ethernet traffic uses.
33Copyright © 2012, Juniper Networks, Inc.
Chapter 6: Connecting the AX411 Access Point

Jupiter AX411 Access Point Specifications

General

Brand	Jupiter
Model	AX411 Access Point
Category	Wireless Access Point
Language	English