Jupiter AX411 Access Point User Manual

CHAPTER 5
Installing the AX411 Access Point
This section includes the following topics:
•
Installing the AX411 Access Point on a Flat Surface on page 23
•
Installing the AX411 Access Point on a Wall on page 23
•
Installing the AX411 Access Point in an Overhead Enclosure on page 25
•
Removing the AX411 Access Point Plastic Cover on page 28
Installing the AX411 Access Point on a Flat Surface
You can install the AX411 Access Point on a desk, on a table, or on another level surface.
The device is shipped with rubber feet attached. The rubber feet are necessary to stabilize
the device on the surface.
To install the device on a level surface:
1. Make sure that the rubber feet are attached to the bottom of the chassis.
2. Place the device on the surface with the Juniper Networks logo facing up.
Related
Documentation
Site Preparation Checklist for the AX411 Access Point on page 15•
Installing the AX411 Access Point on a Wall
To install the AX411 Access Point on a wall, perform the following procedures:
1.
Installing the AX411 Access Point Mounting Bracket on a Wall on page 23
2.
Attaching the AX411 Access Point to a Mounting Bracket Installed on a Wall on page 24
Installing the AX411 Access Point Mounting Bracket on a Wall
To install the access point mounting bracket on a wall:
1. Obtain the optional mounting bracket from your Juniper Networks reseller. The
mounting bracket is not supplied with the access point.
2. Locate the place on the wall where you intended to mount the access point.
23Copyright © 2012, Juniper Networks, Inc.

Jupiter AX411 Access Point Specifications

General

Brand	Jupiter
Model	AX411 Access Point
Category	Wireless Access Point
Language	English