Varning! Slutlig kasseringavdenna produkt bör skötas i enlighet medlandets
alla lagar och föreskrifter.
Related
Documentation
AX411 Access Point Definitions of Safety Warning Levels on page 61•
• AX411 Access Point General Safety Guidelines and Warnings on page 63
• AX411 Access Point Fire Suppression Procedures and Equipment on page 67
• AX411 Access Point Installation Instructions Warnings on page 68
• AX411 Access Point Electrical Safety Guidelines and Warnings on page 74
• AX411 Access Point WiFi Interoperability on page 75
AX411 Access Point Electrical Safety Guidelines and Warnings
•
In Case of Electrical Accident on page 74
•
General Electrical Safety Guidelines and Warnings on page 74
In Case of Electrical Accident
If an electrical accident results in an injury, take the following actions in this order:
1. Use caution. Be aware of potentially hazardous conditions that could cause further
injury.
2. Disconnect power from the access point.
3. If possible, send another person to get medical aid. Otherwise, assess the condition
of the victim, then call for help.
General Electrical Safety Guidelines and Warnings
•
Install the access point in compliance with the following local, national, or international
electrical codes:
•
United States—National Fire Protection Association (NFPA 70), United States
National Electrical Code
•
Canada—Canadian Electrical Code, Part 1, CSA C22.1
•
Other countries—International Electromechanical Commission (IEC) 60364, Part 1
through Part 7
•
Evaluated to the TN power system
•
Locate the emergency power-off switch for the room in which you are working so that
if an electrical accident occurs, you can quickly turn off the power.
•
Do not work alone if potentially hazardous conditions exist anywhere in your workspace.
•
Never assume that power is disconnected from a circuit. Always check the circuit before
starting to work.
Copyright © 2012, Juniper Networks, Inc.74
AX411 Access Point Hardware Guide
To Next Page
Loading...
Need help?
General