About This Guide
•
Objectives on page ix
•
Audience on page ix
•
Documentation Conventions on page ix
•
AX Series Documentation and Release Notes on page xi
•
Obtaining Documentation on page xi
•
Documentation Feedback on page xii
•
Requesting Technical Support on page xii
Objectives
This guide describes hardware components and installation, basic configuration, and
basic troubleshooting procedures for the Juniper Networks AX411 Access Point. It explains
how to prepare your site for access point installation, unpack and install the hardware,
power on the access point, perform initial software configuration, and perform routine
maintenance. After completing the installation and basic configuration procedures
covered in this guide, see the Junos OS WLAN Configuration and Administration Guide and
Junos OS CLI Reference for information about further Junos OS configuration.
Audience
This guide is designed for network administrators who are installing and maintaining
Juniper Networks AX411 Access Points or preparing a site for access point installation.
To use this guide, you need a broad understanding of networks in general and the Internet
in particular, networking principles, and network configuration. Any detailed discussion
of these concepts is beyond the scope of this guide.
Documentation Conventions
Table 1 on page x defines the notice icons used in this guide.
ixCopyright © 2012, Juniper Networks, Inc.
To Next Page
Loading...