Jupiter AX411 Access Point User Manual

CHAPTER 7
Initially Configuring the AX411 Access Point
Wireless LAN
This section includes the following topics:
•
AX411 Access Point Wireless LAN Initial Software Configuration Overview on page 37
•
Installing Licenses for the AX411 Access Point on the SRX Series Device on page 39
•
AX411 Access Point Configuration Example: Layer 2 Mode (CLI) on page 40
•
AX411 Access Point Configuration Example: Layer 3 Mode (CLI) on page 41
•
Configuring AX411 Access Point Country-Specific Settings on page 42
•
Testing Connectivity to the AX411 Access Point Wireless LAN on page 46
•
Returning the AX411 Access Point to the Factory Default Settings on page 46
AX411 Access Point Wireless LAN Initial Software Configuration Overview
The procedures in this topic describe how to establish communication between the AX411
Access Point and the SRX Series Services Gateway that manages it. When this
communication is established, the Status LED on the access point lights green, showing
that the access point is being managed by the services gateway. Then the services
gateway loads a default configuration onto the access point that establishes a basic
wireless LAN.
Once you have established communication between the access point and the services
gateway, you can perform advanced software configuration of the access point as
described in the Junos OS WLAN Configuration and Administration Guide.
If one or more access points are connected to the built-in Ethernet ports on the services
gateway other than ge-0/0/0, and the ports are in their factory default configuration,
each access point will automatically obtain an IP address using DHCP, and the services
gateway will deliver a default configuration to the access point. The Status LED on the
access point will light green, showing that the access point is being managed by the
services gateway. By default, the services gateway will accommodate up to two access
points. You can connect and use more than two access points if you also install access
point licenses on the services gateway.
For services gateways in the SRX200 line, the factory default settings establish a VLAN
consisting of all of the built-in ports except 0/0 (interface ge-0/0/0). These ports all
37Copyright © 2012, Juniper Networks, Inc.

Jupiter AX411 Access Point Specifications

General

Brand	Jupiter
Model	AX411 Access Point
Category	Wireless Access Point
Language	English