JVC A-X3 User Manual

DUBBING
TAPE DUBBING
Tape dubbing means copying the contents of one tape onto
another tape. To perform tape dubbing, two tape decks should
be connected, one for playback and the other for recording.
With this set you can dub from the tape deck connected to
TAPE-1 terminals onto the tape deck connected to TAPE-2
terminals.
1. Press the tape dubbing switch to DUBBING (-=).
2. Operate the TAPE-1 tape deck for playback.
3. Operate the TAPE-2 tape deck for recording.
4. To monitor the sound being recorded, press the TAPE
MONITOR switch in (-— ) and leave the TAPE switch in its
“out” position ( m).
Notes:
@ Deck-to-deck dubbing is possible while listening to any
other source. To do this, release the TAPE MONITOR
switch to the “out” position by re-depressing it (),
operate the two tape decks for dubbing and select any
other source you want to hear with the corresponding
source select switch.
@ Ifa three-head tape deck is used for recording during tape
dubbing, you can monitor the recorded sound while record-
ing by pressing the TAPE MONITOR switch ( —= ) and set-
ting the TAPE switch to “2” (= ).
@ Dubbing from TAPE-2 to TAPE-1 is not possible.
—~15—

JVC A-X3 Specifications

General

Brand	JVC
Model	A-X3
Category	Amplifier
Language	English