MENU SCREENS
76
VIDEO FORMAT[2/2] Menu
Screen
* This is not displayed in VTR mode.
Item Function/Setting (bold characters indicate initial settings)
PB TAPE Selects whether to automatically detect the playback tape video format or play back only a particular format.
Normally, use the “AUTO” setting.
AUTO : During tape playback, the format signal is switched automatically and played back.
DV : During tape playback, only the part of the tape recorded in DV format is played back.
HDV : During tape playback, only the part of the tape recorded in HDV format is played back.
DVCAM : During tape playback, only the part of the tape recorded in DVCAM format is played back.
MEMO
If you play back a tape containing both DV and HDV formats, the video signal is disturbed when the signal is
switched.
SET UP Selects whether to add a setup signal to the composite signal from the VIDEO OUT terminal.
In DV format, a setup signal can be added to COMPONENT output.
* You can also select a setup signal in the IEEE1394 signal input mode.
0.0% : No setup signal is added.
7.5% : A setup signal is added.
Initial settings: U model: 7.5% E model: 0.0%
MEMO
When the FRAME RATE item is set to 50/25, this item is not displayed.
PAGE BACK When the cursor is in this position, press the SHUTTER dial to the VIDEO FORMAT[1/2] menu screen.
e_hd200.book Page 76 Friday, February 1, 2008 4:04 PM
To Next Page
Loading...
