23
Status Screens in the Camera Mode
STATUS 0
1 Event Indication
When the Gain or Shutter Speed is changed manually, the setting condition is displayed for about 3 seconds at the time the
change is made.
• Set the shutter display method to seconds or angle in SHUTTER DISP. on the LCD/VF[3/4] menu screen. (Only when
frame rate is 24p or 25p mode)
266S
DD
STATUS 0 Screen
1
23
9
8
7
6
5
4
0
Setting Status Contents of Indications
Gain value was changed GAIN 0 dB, 3 dB, 6 dB, 9 dB, 12 dB, 15 dB, 18 dB
Gain value reached the ALC GAIN ALC
FULL AUTO was turned ON/OFF FULL AUTO ON, FULL AUTO OFF
ZEBRA was turned ON/OFF ZEBRA ON, ZEBRA OFF
Shutter speed value was changed
*1
(When SHUTTER DISP. is set to SEC)
SHUTTER 1/6, 1/6.25, 1/7.5, 1/12, 1/12.5, 1/15, 1/24, 1/25, 1/30, 1/48, 1/50, 1/60, 1/100, 1/120,
1/250, 1/500, 1/1000, 1/2000, 1/4000, 1/10000
Variable shutter speed value was changed
*1
(When SHUTTER DISP. is set to SEC)
V. SHUTTER 1/24.01 to 1/10489.5
Shutter was turned OFF SHUTTER OFF [1/**]
*4
Shutter speed value was changed
(When SHUTTER DISP. is set to DEG)
SHUTTER 360.0°, 180.0°, 172.8°, 150.0°, 144.0°, 135.0°, 120.0°, 105.0°, 90.0°, 75.0°, 60.0°,
45.0°, 30.0°, 22.5°, 11.2°
Variable shutter speed value was changed
(When SHUTTER DISP. is set to DEG)
24p: 0.82° to 359.4°
25p: 0.85° to 359.4°
White balance value was changed (Example)
WHITE BAL A [3200K]
Numeric value: Any of 2300, 2500, 2800, 3000, 3200, 3400, 3700, 4300, 5200, 5600, 6500,
8000
FILTER value was changed FILTER OFF, FILTER ND 1 [1/4ND], FILTER ND 2 [1/16ND]
AE LEVEL value was changed
*2
AE LEVEL –3, –2, –1, NORMAL, +1, +2, +3
BLACK gain value was changed
*2
BLACK NORMAL
BLACK STRETCH 1, 2, 3, 4, 5
BLACK COMPRESS 1, 2, 3, 4, 5
PRESET TEMP. value was changed
*2 *3
WHITE BAL PRST [3200K], WHITE BAL PRST [5600K]
HEADER REC is running HEADER REC
FOCUS ASSIST was turned ON/OFF FOCUS ASSIST ON, FOCUS ASSIST OFF
Time code was set to zero reset TC ZERO PRESET X Seepage45.
REC LOCK switch was turned ON/OFF REC SWITCH LOCKED, REC SWITCH UNLOCKED X See page 18, 9 REC LOCK switch.
A REC command was sent from the IEEE1394
connector
TRIGGER TO HDV, TRIGGER TO DV
e_hd200.book Page 23 Friday, February 1, 2008 4:04 PM
To Next Page
Loading...
