77
CAMERA OPERATION
Menu Screen
The CAMERA OPERATION menu screen is only displayed in the Camera mode.
*1
REMOTE appears as the setting value of this item when the remote control unit is connected.
Item Function/Setting (bold characters indicate initial settings)
AE LEVEL
*1
For adjusting the image level when using auto iris, “ALC” or “EEI”.
Increase value : Increases level.
Decrease value : Decreases level.
[Settings: –3, –2 - NORMAL (0) - 2, 3]
ALC MAX Sets the maximum “ALC” value to automatically change the signal intensity level depending on the brightness.
[Setting: 6 dB, 12 dB, 18 dB]
PRESET TEMP. Sets the basic color temperature when the [WHT.BAL] white balance selector switch c on page 15 is in the PRST
(PRESET) position.
3200K : Sets the basic color temperature to 3200K. (Use for light sources with a low color temperature,
such as halogen lamps.)
5600K : Sets the basic color temperature to 5600K. (Use for light sources with a high color temperature,
such as sunlight.)
MEMO
This item does not function when the FAW item on the SWITCH MODE menu screen is set to “PRESET”.
SMOOTH TRANS
*1
Smoothens the transition when the [GAIN] switch b on page 15, or [WHT.BAL] switch c on page 15 is switched
over and achieves gradual change in place of sudden change.
However, the smooth transition function does not function when switching the [GAIN] switch set in ALC, FULL AUTO
ON.
OFF : Deactivates the smooth transition function.
ON : Activates the smooth transition function.
BARS
*1
Sets whether or not color bars are output. (This is fixed at “OFF” when in FULL AUTO mode)
OFF : Color bars are not output.
ON : Color bars are output.
PAGE BACK The TOP MENU returns when the SHUTTER dial is pressed with the cursor at this position.
e_hd200.book Page 77 Friday, February 1, 2008 4:04 PM
To Next Page
Loading...
