64
Dubbing with AV Devices
By connecting the video signal output terminal and the
AUDIO OUTPUT terminal on this device to an AV device,
analog signal dubbing is possible.
1. Connect the cables.
2. Turn both devices on.
3. Set this device to VTR mode.
Press the CAM/VTR button. The VTR indicator lights.
4. Set the video output.
Set the VIDEO FORMAT menu screen. X See page 74.
• HDV PB OUTPUT item:
Set the video format to be output from the video output
terminal during tape playback.
• PB TAPE item:
Select whether to automatically detect the playback tape
video format or play back only a particular format.
Normally, use the “AUTO” setting.
5. Set the audio output. X Seepage62.
Set the AUDIO menu screen. X See page 84.
• PB AUDIO CH [DV] item:
Set the audio channel to be output.
6. Insert the videocassettes.
7. Press the PLAY/STILL button on this device to start play-
back.
8. Start recording on the recording unit.
For details, see the instructions to the unit used for
recording.
9. When dubbing is completed.
Stop recording on the recording unit, and then press the
STOP button on this device to stop playback.
IEEE 1394
CH2-AUDIO OUT-CH1 VIDEO
Signal flow
Recording unit
AUDIO
OUTPUT
connector
Signal flow
Composite cable
or
Component cable
VIDEO FORMAT menu screen
1080I CAMERA OFF
This device : Insert the recorded videocas-
sette.
Recording unit : Insert the videocassette to be
dubbed to.
AUDIO menu screen
e_hd200.book Page 64 Friday, February 1, 2008 4:04 PM
To Next Page
Loading...
