47
Recording Time Codes in
Continuation of Time
Codes Recorded on Tape
This device also incorporates a time code reader. Therefore,
when this device enters record mode from record-standby
mode, it can read the time code data recorded on the tape
and record time codes in continuation of the existing data.
The recorded user’s bit data are identical to the user’s bit
date recorded on tape.
* However, approximately ±1-frame variations may occur in
scene accuracy.
To enable this function, set the time code related switches as
follows before starting recording.
Setting
• Set the TC GENE. switch inside the LCD door to REGEN.
• Set TC DUPLI. item on the TC/UB/CLOCK menu screen
to OFF.
MEMO
The time code framing mode automatically becomes the
mode (drop frame or non drop frame) already recorded on
the tape.
Playing Back Time Code
This device features a time code reader. During playback,
the time code or user’s bit data recorded on the tape is dis-
played on the LCD screen or viewfinder status screen.
MEMO
• During playback, if a portion of tape without recording
time code runs through, the time code stops running.
Playback continues.
• When a tape with a time code that is longer than two
hours is played on home-use DV equipment, time code
may not be played properly on some models.
About Time Code Mode
Camera mode
VTR mode/IEEE1394 input mode
*
IEEE1394 TC SLAVE mode is performed with special operations. X See page 48.
TC GENE. switch
FREE REC REGEN
TC PRESET mode TC REGENE mode
TC/UB/CLOCK menu TC GENE. switch
TC DUPLI. item FREE REC REGEN
OFF
IEEE1394 TC
SLAVE mode*
TC PRESET mode TC REGENE mode
ON IEEE1394 TC DUPLI. mode
e_hd200.book Page 47 Friday, February 1, 2008 4:04 PM
To Next Page
Loading...
