JVC GY-HM150U - Page 22

1-22 (No.HC044<Rev.001>)
(3) [PIXEL COMPEN EXECUTING] is displayed and the de-
tection required for white blemish correction automatically
starts.
At this time, the camera lens is closed and the mode
changes to the SLOW SHUTTER mode.
(4) When the white blemish detection completes, the result
data is stored in the CPU memory, and an end message is
displayed as shown below. Turn OFF the power.
(After completing white blemish detection, the "Camera
Resolution" and "Frame & Bit Rate" settings return to the
original settings.)
(5) If any errors occur during the detection, an error message
is displayed, then the screen returns to the MENU display.
5.1.4 DIP SW Menu Operation
(1) Refer to 5.1.1 to display the SERVICE MENU.
(2) Move the cursor to [DIP SW], then press the [Set] button or
the [Cross-Shaped] button (right).
(3) The DIP SW MAIN Menu is displayed.
Message Error details Operation
LENS NOT
CLOSED?
The lens does not close
for detection.
No result is stored in the
EEPROM.
COUNT
OVER
The number exceeds
the specified count.
Only the specified
count of data is stored
in the EEPROM.
PIXEL COMPEN
ERROR
SD CARD
TURN POWER OFF
AND ON AGAIN.
PIXEL COMPEN
EXECUTING
PIXEL COMPEN
END
TURN POWER OFF
AND ON AGAIN
--- DIP SW ---
DIPSW ALL RESET
DIP SW 0-7..
DIP SW 8-15..
DIP SW 16-23..
DIP SW 24-31..
DIP SW 32-39..
DIP SW 40-47..
DIP SW 48-55..
DIP SW 56-63..
BACK
--- DIP SW 1/8 ---
DIP SW 0 0
DIP SW 1 Off
DIP SW 2 Off
DIP SW 3 Off
DIP SW 4 Off
DIP SW 5 Off
DIP SW 6 Off
DIP SW 7 Off
BACK
--- DIP SW 2/8 ---
DIP SW 8 Off
DIP SW 9 Off
DIP SW 10 Off
DIP SW 11 Off
DIP SW 12 Off
DIP SW 13 Off
DIP SW 14 Off
DIP SW 15 Off
BACK
--- DIP SW 3/8 ---
DIP SW 16 Off
DIP SW 17 Off
DIP SW 18 Off
DIP SW 19 Off
DIP SW 20 Off
DIP SW 21 Off
DIP SW 22 Off
DIP SW 23 Off
BACK
--- DIP SW 4/8 ---
DIP SW 24 Off
DIP SW 25 Off
DIP SW 26 Off
DIP SW 27 Off
DIP SW 28 Off
DIP SW 29 Off
DIP SW 30 Off
DIP SW 31 Off
BACK