Registering/Deleting Preset Zoom
Registering Preset Zoom
You can register any 3 zoom positions.
1
Set to the Register Preset Zoom mode.
Tap (click) the [Preset] button to switch to the
Register Preset Zoom mode.
.
2
Determine the zoom position.
Use the zoom control to operate the zoom and
determine a position.
3
Tap (click) [A].
Position [A] is registered, and position A is
displayed
on
the sliding bar of the zoom control.
.
4
In the same way, register [B] and [C].
After all three positions A, B and C are
registered, the positions of the [A], [B], and [C]
buttons will be rearranged according to the
order of the registered zoom position from the
left.
.
5
Exit the Register Preset Zoom mode.
Tap (click) the [Preset] button to exit the
Register Preset Zoom mode.
Memo :
0
After registration is complete ([A]
, [B], and [C]
buttons are all active), tapping (clicking) each
button switches to the corresponding preset
zoom position.
0
This function operates independently of the
preset zoom position on the camera recorder.
(A P49 [Saving/Recalling Current Zoom
Position (Preset Zoom)] )
167
Connecting to the Network
a
To Next Page
Loading...
