232 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
9.2 Register Descriptions.
Be aware that some of the commands only applies for specific protocols.
Common commands
Command no. Command description
Hex Dec MAC050 - MAC141 MAC400 – MAC4500 MIS/MILxxx
Module only commands
0x 0000 0000 0 No operation < Same as < Same as
0x 0000 0001 1 Reset the module < Same as < Same as
0x 0000 0010 16 Save module parameters to flash < Same as < Same as
0x 0000 0011 17
Flash with power LED for 120 seconds.
Only applicable for MAC motors. For MIS/MIL
motors use commands specific for MIS/MIL.
< Same as < Same as
0x 0000 0012 18 Restore factory defaults. < Same as < Same as
0x 0000 0013
19 Copy Sync0 pulse to Out1 < Same as No operation
0x 0000 0014 20 Remove Sync0 from Out1 < Same as No operation
Synchronized commands
0x 0000 0101 257
Simultaneous reset of the motor and the
module
< Same as < Same as
0x 0000 0110 272
Save the motor parameters in flash
memory, and do a re-sync. of internal
communication afterwards.
< Same as < Same as
To Next Page
Loading...