JVL MAC00-EC41 - Connector Description

22 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
2.3 Connector description
2.3.1 Expansion module MAC00-Ex4 (basic version) connector description
The MAC00-Ex4 offers IP65 protection and M12 connectors which makes it ideal for au-
tomation applications where no additional protection is desired. The M12 connectors of-
fer solid mechanical protection and are easy to unplug.
The connector layout:
(Continued next page)
“PWR” - Power input. M12 - 5pin male connector
Signal name Description Pin no.
JVL Cable
WI1000-
M12F5T05N
Isolation
group
P+
Main supply - Connect with pin 2 *
When installed in MAC050 to 141 = 12-48VDC
When installed in MAC400-4500 = 18-30VDC
1 Brown 1
P+ Main supply - Connect with pin 1 * 2 White 1
P- Main supply ground. Connect with pin 5 * 3 Blue 1
CVI
Control supply nominal +12-48VDC.
DO NOT connect >50V to this terminal !
A small leakage current may exist on this pin if
not used.
Connect this terminal to ground if not used.
4 Black 1
P- Main supply ground. Connect with pin 3 * 5 Grey 1
* Note: P+ and P- are each available at 2 terminals. Make sure that both terminals are connected in order to
split the supply current in 2 terminals and thereby avoid an overload of the connector.
Only MAC
Expansion module MAC00-Ex4 front plate
L/AIN
PrimaryEthernet
channe l
M12‐4pinfemale
Ethe r netcoded
(Dcoded)
L/AOUT
SecondaryEthernet
channe l
M12‐4pinfemale
Ethe r netcoded
(Dcoded)
Usedwhenmodule
isdaisychained
TT3002GB
PWR
Powersupply
M12‐5pinmale
connectorincluding:
and
P+(prim ar ysupply),andCVI
(secondarysupply) P‐
I/O
I/O’sandRS232interface
M12‐8pinfemale
connectorincl ud i ng :
1digitalinputand1digital
output,1analogueinput