92 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
4.4 Commissioning
4.4.1 Necessary equipment
To get started you will need the following equipment.
• MAC motor with an EthernetIP module (MAC00-EIx) or a MIS/MILxxxxxx-
EIxxxx motor.
• A PLC or master controller with EthernetIP interface and relevant software
• A PC installed with MacTalk software in order to setup the MAC motor.
• Relevant signal and low voltage cables such as Ethernet cable, 24V power
cable, RS232 cable. Please also see the section
Cable accessories, page 26.
• A 24VDC supply able to deliver min.1000mA@24V pr. motor used.
• Concerning AC high voltage supply for the MAC motor please refer to the
general MAC motor user manual (LB0047-xx)
The general MAC or MIS/MIL motor user manual can be downloaded from http://
www.jvl.dk
!
To Next Page
Loading...