26 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
2.4 Cable accessories
2.4.1 Cables for the MAC00-Ex4 (basic version)
The following cables equipped with M12 connector can be supplied by JVL.
Important: Please note that the cables are a standard type. They are not recommended for use in ca-
ble chains or where the cable is repeatedly bent. If this is required, use a special robot cable (2D or 3D
cable).
MAC00-Ex4 Connectors Description JVL Order no. Picture
“L/A IN”
4pin
male
“L/A OUT”
4pin
Female
“I/O”
8pin
Female
“PWR”
5pin
Male
X
RS232 Interface cable. Connects
directly from MAC00-Ex4 to a PC
Length: 5m (197 inch)
RS232-M12-1-5-8
X
Cable with M12 male 8-pin
connector loose wire ends
0.22mm² (24AWG) and screen.
Length: 5m (197 inch)
WI1000-M12M8T05N
X
Same as above but 20m (787 inch)
WI1000-M12M8T20N
X
Cable (Ø5.5mm) with M12 female
5-pin connector loose wire ends
0.35mm² (22AWG) and foil screen.
Length: 5m (197 inch)
WI1000-M12F5T05N
X
Same as above but 20m (787 inch)
WI1000-M12F5T20N
X X
Ethernet cable with M12 male 4pin D
coded straight connector, and RJ45
connector (fits into std. Ethernetport)
WI1046-M12M4S05NRJ45
X X
Ethernet cable with M12 male 4pin D
coded straight connector, loose ends.
WI1046-M12M4S05R
X X
Same as above but 15m (590 inch)
WI1046-M12M4S15R
Protection caps. Optional if connector is not used to protect from dust / liquids.
X X
IP67 protection cap for M12
female connector.
WI1000-M12FCAP1
X X
IP67 protection cap for M12
male connector.
WI1000-M12MCAP1
To Next Page
Loading...