242 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
10.1 Using MacTalk over Ethernet
The PC from where MacTalk is used needs to be configured for this IP range.
The in depth PC – configuration is beyond the scope of this manual since this greatly de-
pends on the networks equipment end network connected. However a brief description
on how to configure the IP address manually is discussed. This method is necessary if the
motor is connected directly to the Ethernet port in the PC or if the network isn’t capable
of assigning IP addresses to connected equipment automatically.
NOTE!
With laptops or desktops with more than one network card, ie. a wireless one, it can be
necessary to turn off the unused one, to force windows to route the requests the correct
way.
To Next Page
Loading...