244 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
10.2 Setting up the Ethernet at the PC
Step 2.
Find the “Internet protocol version 4 (TCP/IPv4)” and press “Properties”.
Now the settings finally appears and we are able to change the IP address, subnet mask
and gateway.
Step 3.
Select “Use the following” and enter a valid configuration similar to the one below.
The above example is a basic settings that sets the IP address on the PC to 192.168.0.59,
subnet mask to 255.255.255.0 and the gateway to 1.1.1.1.
Now the PC is configured for a fixed IP address and is ready to establish the connection
to the motor.
TT3072-01GB
Press «Properties»
Find the «Internet protocol
version 4 (TCP/IPv4)»
To Next Page
Loading...