246 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
10.2 Setting up the Ethernet at the PC
Then it is possible to setup the JVL Motors for working correctly with EoE. Please follow
the steps shown below.
Step 4.
Check the “IP Enable Router” in the EoE support. If not already checked, then a reboot
of the EtherCAT master is necessary.
Step 5.
Find the IP addresses of the interfaces in the EtherCAT master. If necessary then change
them to something suitable (beyond the scope of this manual).
To Next Page
Loading...