250 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
10.3 Setting up MacTalk for Ethernet
Step 4.
Lets assume that the motor with the IP address 192.168.0.58 is connected to the PC
from where MacTalk is running or the same network that the PC is running, we enter
the IP address.
Step 5.
Since it is the first time the address is entered MacTalk offers the possibility to sign in the
IP address and assign an alias name to this IP address which is stored and later be shown
in the address field instead of remembering the IP address of the motor. This greatly
helps managing multiple motors in a network instead of handling all the ”anonymous” IP
addresses.
Step 6.
The following dialog appears when a new address is entered.
Step 7.
Pressing “Yes” will show the list of IP addresses and user composed names.
Insert the IP-address here
TT3076-01GB
To Next Page
Loading...