805.65
K-Commander Loss-in-Weight Programming
Rev: G Produced by the K-Tron Institute
LWF Page 07: Service Variable Index, Continued
Service
variable index
and value
listing con't
SAB Output Range 1
This entry allows you
to set the analog
output range
0 = Disa
1 = 0 to 10 V
2 = 0 to 20ma
3 = 4 to 20ma
SAB Output Range 2 Same as output 1
SAB Output Range 3 Same as output 1
SAB Output Value 1
This is the current
value for output 1
Read only
SAB Output Value 2 This is the current
value for output 2
Read only
SAB Output Value 3 This is the current
value for output 3
Read only
SAB Output 1 Calib
Value
See document 6503
for calibration
instructions
SAB Output 2 Calib
Value
Same as above
SAB Output 3 Calib
Value
Same as above
Continued on next page
To Next Page
Loading...
