43
L. INSTALLING RUBBER BUMPERS
L- 1 Close the door and apply pressure making
sure the deadlatch (a) rests on the strike
plate (b) as shown. Standing on the frame
(door stop) side of the door, check for gaps
between the door and the frame on the
three sides of the frame (left, right, and top).
L- 2 Mark locations where the gaps are
approximately
3
⁄16" (5 mm). Make sure
these locations are free from grease and
dust. Peel the bumpers (c) from their
protective backing without touching the
adhesive surface and stick them on the
marked locations.
Note: Allow 24 hours for adhesive to set before testing.
The door may be operated normally during this time.
M. INSTALLING BATTERY PACK
(Not for PowerStar Versions)
Note: If the lock makes a continuous buzzing
noise or the red LED lights continuously, reset
the electronics by removing the battery holder
for ten seconds, then reinsert it.
M-1 Three AA batteries should already be
installed in the battery holder (q).
M-2 Insert the battery holder into the outside
housing and secure it using the 6-32 x
5
⁄16"
(8 mm) screw (r).
c
a
Correct
b
q
r
To Next Page
Loading...
Need help?
General
