Page 2
INSTALLATION GUIDE - REMOTE ACCESS CONTROLLER RAC 4XT • PK3191_10_14
Target Audience
Please read and follow all directions
carefully. These instructions are designed
for use by qualified installers or individuals
with knowledge of common safety practices
and the competence to perform the steps
described herein.
Kaba Ilco is not responsible for damage or
malfunction due to incorrect installation.
Warnings and Cautions
Carefully inspect windows, doorframes,
doors, etc. to ensure that the installation
procedures will not cause any damage.
Kaba Ilco’s standard warranty does not cover
damages caused by installation.
The RAC 4XT should always be installed in a
secured room or facility with controlled access
to prevent access to the system.
Installation of card readers or other
peripherals within elevators must only
be done with prior consultation of the
elevator manufacturer. A technician from
the manufacturer should be present at all
times for installation.
If installing the RAC 4 in an elevator cage
environment, or in proximity to any other
equipment that may generate high levels
of electromagnetic interference, follow
the installation requirements as indicated
in Annex C to prevent any operational
instability.
Safety Procedures
Installation is to be done following standard
safety procedures, and using adequate
equipment and protection as prescribed.
Power is to be off during the installation
process as well as for any maintenance
procedures.
CAUTION:
Wear safety glasses when using any
tools.
Technical Support
For technical assistance, call:
(800) 906-4526 / (514) 340-9025
OR
Visit the Kaba Support Website:
www.kabalodgingsupport.com
NOTE:
This equipment has been tested and found to
comply with Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Statement according to FCC part 15.21
Modifications not expressly approved by Kaba
Ilco could void the user's authority to operate
the equipment.
Statement according to FCC part 15.19
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any
interference received, including
interference that may cause undesired
operation.
1.0 Introduction and Disclaimers
!
!
!
!
To Next Page
Loading...
