Kaba Saflok SYSTEM 6000 - 4.3 Using a Standard Magstripe Keycard

To Next Page

To Previous Page

System6000

TM

ReferenceManual_Section4

4.3UsingaStandardMagstripeKeycard



Thecardmustbeproperlyinsertedintothelocksothattheinformationonthecardcanbereadbythereadhead

containedwithinthelock.



1. Insertthekeycardfullyintothelockwiththearrowsidefacingup.

Makecertainthatthearrowsprintedonthefaceofthecardare

pointingtowardsthelock.



2. Removethecardassoonasithasbeenfullyinsertedintothelock.If

usingasmartormemorycard,waitforthegreenlightbeforeremoving

thekeycard.Thelockwillnotoperateuntilthekeycardhasbeen

removed.



3. Aflashinggreenlightwillappearonthefrontofthelockassoonasthecardis

removed.Thelightwillflashforsixseconds.



4. Whilethegreenlightisflashing,turnthehandletoopenthe

door.If

thehandleisnotturnedwhilethegreenlightisflashing,thelatching

mechanismwillbereturnedtothelockedposition.



Page7of1606_11