Kaco blueplanet 10.0 NX3 M2 User Manual

Page 37 KACO blueplanet 3.0 NX3 M2 KACO blueplanet 5.0 NX3 M2 KACO blueplanet 8.0 NX3 M2 KACO blueplanet 10.0 NX3 M2
KACO blueplanet 15.0 NX3 M2 KACO blueplanet 20.0 NX3 M2
9.8.4 Resetting a faulty connection

<Communication unit> is open.
Note: The communication unit is restarted
via the <Restart communication unit> icon.
Set values on the device are not reset.
1. Press the <Confirm> button in the
warning message to trigger a restart.
Important: Pressing <Reset
communication unit> resets all created
configurations to the factory defaults.
2. Reset the communication unit with
<Reset communication unit>.
» Check the connection after restart.
Fig. 72. Note for <Restart communication unit>
All configurations remain unchanged.
Fig. 73. Reset / restart the
communication unit
Fig. 74. Observe the note on
resetting the communication
unit!
NOTE
The following settings are reset when the communication unit is reset:
• Network configurations
• Feedin and Smart-Meter Settings
• Function Monitoring & Control
• Time Zone
• Internal inverter list from the communication unit is deleted from the memory.
Note: Inverter settings are not reset by the communication unit during a restart.

Kaco blueplanet 10.0 NX3 M2 Specifications

General

Model	blueplanet 10.0 NX3 M2
Manufacturer	Kaco
Category	Inverter
Max. AC Output Power	10000 W
Max. DC Voltage	1100 V
Number of MPPTs	2
Max. apparent AC power	10000 VA
AC frequency	50 Hz / 60 Hz
Max. AC current	16 A
Max. DC current	26 A
Protection class	IP65
Topology	Transformerless
Operating Temperature Range	-25°C to +60°C
Cooling	Convection
Max. DC power	15000 W
AC Output Voltage	230 V / 400 V
AC voltage range	230 V / 400 V