EasyManuals Logo

KAESER CSD 102 Service Manual

KAESER CSD 102
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
Initial Start---up
7 --- 39
7.8 Initial Start---up
Open the shut---off valve to the air network.
Switch on at the main supply isolator.
The controller makes a self---test and the green LED ’Power ON lights.
Press the Operating state LOAD/IDLE key.
Press the ON’ key.
The green LED ’Machine ON’ lights.
Allow the machine to idle for at least one minute.
This ensures good distribution of cooling oil.
Press the Operating state LOAD/IDLE key.
The machine switches to the LOAD state and delivers compressed air.
Watch for any faults occurring in the first hour of operation.
After the first 50 operating hours carry out the following:
Check that all electrical connections are tight.
7.9 System pressure setting
The system pressure p1 is factory set to the highest possible value.
Adhustment is necessary for individual operating conditions.
System pressure setting is described in the SIGMA CONTROL service manual.
The machine may toggle a maximum of twice per minute between LOAD
and IDLE.
Reducing starting frequency:
Increase the difference between cut---in and cut---out pressure.
Add an air receiver downstream to increase buffer capacity.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KAESER CSD 102 and is the answer not in the manual?

KAESER CSD 102 Specifications

General IconGeneral
BrandKAESER
ModelCSD 102
CategoryAir Compressor
LanguageEnglish

Related product manuals