10
Insert and replace the batteries
Replace the batteries immediately when the symbol
appears in the display� Disconnect the meter from
the power source� Remove the test leads from the
measuring device, loosen the screws on the back
and remove the lower half of the housing, replace
the old batteries and screw the cover back on�
Turn on/o the meter
The device is switched on when the rotary switch (5) is set to a measuring function
When the rotary switch is set to OFF, the measuring device is switched o.
Automatic shutdown
No operation in 15 minutes, the clamp meter beeps 3 times� Without further operation,
Operating Instructions
To Next Page
Loading...
