2
terminals
or between any terminal and earth ground�
• Remove test leads from the Meter before opening the Meter case�
• Never operate the Meter with the back cover removed or the case open�
• Never remove the back cover or open the case of an instrument without rst removing
the test leads or the jaws from a live conductor�
• Use caution when working with voltages above 30 V ac RMS, 42 V ac peak, or 60 V
dc� These voltages pose a shock hazard�
• Do not attempt to measure any voltage that might exceed the maximum range of the
Meter- 1000 V RMS�
• Do not operate the Meter around explosive gas, vapor, or dust�
• When using probes, keep ngers behind the nger guards.
• When making electrical connections, connect the common test lead before
connecting the live test lead; when disconnecting, disconnect the live test lead before
disconnecting the common test lead�
• Disconnect circuit power and discharge all high-voltage capacitors before testing
resistance,continuity, or diodes�
• Check the operation of the meter at a known source before and after use�
To Next Page
Loading...
