5. Move dispenser valve group
and pull out Teflon pipe which
connected thermoblock
6. Move dispenser valve group and
pull out Teflon pipe which
connected thermoblock
7. Disassemble hooks from support,
and take out thermoblock group
4.2.16 Disassemble ground coffee container lid switch group
8. Disassemble hooks from the
support and take out thermoblock
2. Disassemble 1 screw from dispenser
valve 3W so that the wiring can be
taken out from the cable rack
3. Pull out motor group terminal from
PCBA and separate with cable rack
To Next Page
