Kamic Installation ZEUS4-VD - 9 Zeus4-VD Programming Mode; Programming Telephone Numbers - Tn

ZEUS-VD INSTALLER’S MANUAL
9 ZEUS4-VD PROGRAMMING MODE
All data, programming values and telephone numbers need to be stored in the phone book located
on the SIM card. The ZEUS4-VD is possible to program on 4 different ways:
⇒ Using the USB SIM manager on the PC - recommended
⇒ directly on SIM card using personal mobile phone
⇒ Remotely by SMS command
⇒ With PC Via USB port*
* not supported yet
NOTE:
The PIN number on the SIM card must be erasing before programming procedure!!!
Disconnects the power supply from the unit when remove or insert the SIM card!
9.1 PROGRAMMING TELEPHONE NUMBERS - TN
PROGRAMMING TABLE – DIRECT PROGRAMMING ON THE SIM CARD
ZEUS4-VD - GSM PROGRAMMING TABLE
SIM CARD PHONE BOOK
Name Phone (Number) Description
TN1
1
s
t
telephone number
TN2
2
n
d
telephone number
TN3
3
r
d
telephone number
TN4
4
th
telephone number
TN5
5
th
telephone number
TN6
6
th
telephone number
TN7
7
th
telephone number
TN8
8
th
telephone number
TN9
9
th
telephone number
TN0
10
th
telephone number
ZEUS4-VD send an alarm recorded voice message, an alarm SMS message or both. If the
corresponding name ends with the letter “V”, when only voice message is sent; and if the name
ends with the letter “M”, only the SMS message is sent. When the name ends with letter “D” the
unit will be use for the door entry system.
By pressing the * you will switch off the redial call for calling number. The remaining
numbers will be called as usual.
By pressing the # you will switch off all remaining calls.
Example: When you need sending an alarm voice message and the SMS message to the first
telephone number, only alarm voice message to the second one and only an SMS message to the
third one. (See the table below.)
Page
9