Kamic Installation ZEUS4-VD - 12 Checking and Changing the System Status (On;Off); Checking System Status by Sms Command; Checking System Status by Dtmf Command; Changing System Status off to on (System On)

ZEUS-VD INSTALLER’S MANUAL
12 CHECKING AND CHANGING THE SYSTEM STATUS
(ON/OFF)
12.1 CHECKING SYSTEM STATUS BY SMS COMMAND
Sending this command to the ZEUS4-VD you will get back the SMS with state of the system.
Command ;SYS;
The replay SMS can be:
⇒ ;SYS= ON; System is ON (active inputs)
⇒ ;SYS= OFF; System is OFF (inputs are not active)
12.2 CHECKING SYSTEM STATUS BY DTMF COMMAND
If you want to check the system status (system ON/OFF) with DTMF command then you should
call the ZEUS4-VD and after beep press command “62”. You can hear following response:
⇒ 1 beep ……system is ON (all alarm inputs are enable)
⇒ 3 beeps……system is OFF (all alarm inputs are disable)
12.3 CHANGING SYSTEM STATUS OFF TO ON (SYSTEM ON)
Sending this command to the ZEUS4-VD you will switch the system ON.
Command ;SYS=1;
If you want to get the confirmation SMS back then write “+” before SMS command:
Command ;+SYS=1;
12.4 CHANGING SYSTEM STATUS ON TO OFF (SYSTEM OFF)
Sending this command to the ZEUS4-VD you will switch the system OFF.
Command ;SYS=0;
If you want to get the confirmation SMS back then write “+” before SMS command:
Page
33
Command ;+SYS=0;