Kamic Installation ZEUS4-VD - LN6 Remote Programming by SMS; Main Power Lost Filterlter Parametr - Main; Programming Table for MAIN POWER LOST Filter - MAIN; MAIN POWER LOST Filter Remote Programming by SMS

ZEUS-VD INSTALLER’S MANUAL
Example:
ZEUS4-VD - GSM PROGRAMMING TABLE
SIM CARD PHONE BOOK
Name Number (Default) Description
LN6
12
Low Battery SMS will be send to TN1 and TN2
9.9.2 LN6 remote programming by SMS
For the upper example send the following SMS from the host phone to the ZEUS4-VD:
;LN6=12;
If you want to get the confirmation SMS back then write “+” before SMS command:
;+LN6=12;
9.10 MAIN POWER LOST FILTERLTER PARAMETR - MAIN
Parameter MAIN determinate length of the pulse which is required to create the alarm after the
main power is lost. This time can be from 1 second up to 9999 seconds. The default value is 5
seconds.
For example: When the ZEUS4-VD will be without main power supply more than 5 seconds
(default) then will send the SMS message with following text: “Main Power Lost”.
At the moment when the main power will come back the ZEUS4-VD will send the SMS message
with following text: “Main Power restored”.
9.10.1 Programming table for “MAIN POWER LOST” filter – MAIN
ZEUS4-VD - GSM PROGRAMMING TABLE
SIM CARD PHONE BOOK
Name Number (Default) Description
MAIN
5
Main Power Lost filter (5 seconds default)
9.10.2 “MAIN POWER LOST” filter remote programming by SMS
For the upper example send the following SMS from the host phone to the ZEUS4-VD:
;MAIN=5;
If you want to get the confirmation SMS back then write “+” before SMS command:
Page
19
;+MAIN=5;