Kamic Installation ZEUS4-VD - 11 Print-Out of the Parameters; Receive All Parameters (PALL); Receive Telephone Numbers (PTN); Receive Links (PLN)

ZEUS-VD INSTALLER’S MANUAL
11 PRINT-OUT OF THE PARAMETERS
11.1.1 Receive all parameters (PALL)
Command ;PALL;
Sending this command to the ZEUS4-VD you will get 14 SMS back from it with all parameters that
are currently programmed in the unit.
11.1.2 Receive telephone numbers (PTN)
Command ;PTN;
Sending this command to the ZEUS4-VD you will get back the SMS with all currently programmed
telephone numbers (TN1 – TN0).
11.1.3 Receive links (PLN)
Command ;PLN;
Sending this command to the ZEUS4-VD you will get back the SMS with all currently programmed
links (LN1 –LN9).
11.1.4 Receive input parameters (PIN)
Command ;PIN;
Sending this command to the ZEUS4-VD you will get back the SMS with all currently programmed
Input parameters (IN1 – IN4).
11.1.5 Receive input filter value (PID)
Command ;PID;
Sending this command to the ZEUS4-VD you will get back the SMS with all currently programmed
Input filters (ID1 – ID4 and ION).
11.1.6 Receive delay before dial value (PDD)
Command ;PDD;
Sending this command to the ZEUS4-VD you will get back the SMS with all currently programmed
Input filters (DD1 – DD4 and DON).
11.1.7 Receive clip identification functions (PTC)
Command ;PTC;
Page
30
Sending this command to the ZEUS4-VD you will get back the SMS with all currently programmed
CLIP function to dedicated telephone number (TN1 – TN0) and number of rings before answer-
RAN.