Kamic Installation ZEUS4-VD - Receive Access Telephone Numbers (PSL); Receive Output Parameters (POS); Receive Link for Local Alarm Output (POD); Receive All Programmed SMS Messages (P#)

ZEUS-VD INSTALLER’S MANUAL
11.1.8 Receive access telephone numbers (PSL)
Command ;PSL;
Sending this command to the ZEUS4-VD you will get back the SMS with programmed SL level.
11.1.9 Receive output parameters (POS)
Command ;POS;
Sending this command to the ZEUS4-VD you will get back the SMS with all currently programmed
Outputs parameters (OS1 – OS4).
11.1.10 Receive link for local alarm output (POD)
Command ;POD;
Sending this command to the ZEUS4-VD you will get back the SMS with all currently programmed
direct output alarm links (OD1 – OD8).
11.1.11 Receive all programmed SMS messages (P#)
Command ;P#;
Sending this command to the ZEUS4-VD you will get back the SMS with all currently programmed
alarm SMS’s (#0 - #4)
11.1.12 Receive the power level on the unit (PPWR)
Sending this command to the ZEUS4-VD you will get back the SMS with current main power level
in volts or current battery voltage when the unit runs on the back-up battery.
11.1.13 Receive set up parameters value (PPA)
Command ;PPA;
Sending this command to the ZEUS4-VD you will get back the SMS with all currently programmed
Set-up parameters (LPA, TST, CRE, MNF, MAIN…).
11.1.14 State of the credit for the PRE-PAY CARD
⇒ CC1
Command ;PCC1;
Sending this command to the ZEUS4-VD you will get back the SMS with Credit amount on your
Pre-pay SIM card (for Simobil, Mobitel and Debitel GSM provider).
⇒ CC2
Command ;PCC2;
Sending this command to the ZEUS4-VD you will get back the SMS with Credit amount on your
Pre-pay SIM card (for TIM GSM Italian provider).
⇒ CC3
Page
31
Command ;PCC3;